Hello, tell me please, can I control “Mecanum Wheel Robot Kit” from PC, via 2.4G Wireless Serial? What do I need for this? Thanks for any help.
Using 2.4GHz connection for "Mecanum wheel Robot Kit"
tech_support
#2
Yes, it is possible.
You need connect the pins on 2.4G wireless module to the correspoding pins on Orion board by same way.
Note, the TX, RX on the Orion board should go to RX, TX pin on 2.4G serial module.
Thank you. Please tell me what utilities to use and how to create commands?
If possible, give a step-by-step instruction. I don’t quite understand how to implement this in practice.
tech_support
#4
Hi nikitaromancov,
For the advanced usage for personal application , I am afraid that there is not step by step instructions. We encourage users can try it out by themselves for this kind case.
Anyway, here is a wiring connection picture to you for reference:
The 2.4G wireless serial connection is to provide wireless serial communication between the Makeblock mainboard and the mBlock software. So you can use mBlock software and program on mBlock.
For further application, you may need to figure it out by yourself.
