Im using the upload mode, but I cant seem to figure out how to retrieve info from my mbot. Im using c within the mblock program, I’ve tried using Serial.print but I don’t see any of my info being sent from my mbot. Is there any way I can send variable values from my mbot to my computer to read?
Send info from mbot to computer
Best_codes
#2
If you have Arduino installed on your device (https://www.arduino.cc/en/software), you can open the serial monitor and use it there. mBlock does not have a serial monitor.
system
#5
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.