Request: Add "Upload mode broadcast" Extension for Published Device

#1

Hello, Can I add “Upload mode broadcast extension” for my published device?
Device ID is “st_arduino”.
I look forward to your reply.

Best Regards,

#2

I will ad it when I have time. Sorry for the delay.

#3

Thank you for your reply. I will wait for the extension.
Thanks.

Best Regards,

#4

The device support for the extension is in review. Please allow up to a 2 week delay.

#5

Thank you for your help.

Best Regards,

#6

No problem! I’m glad I could help!

#7

Hello, I found that “upload mode” had added in my device extension.
Is it working?
I’ve downloaded and tested but I think it’s not working properly :frowning:

How did I checked :

  1. Launch “mBlock”
  2. Add device “스팀 아두이노” developer : gostreamlib
  3. Click “+ extension” bottom of the screen.

Could you give me some advice?
Thanks.

Best regards.

#8

Oh, I think source code for “upload broadcast” is not uploaded in “Extension Builder” .
Am I right?

Best Regards,

#9

Yes, you are right.

#10

OK, I’ll wait for your code then.
Thanks for your help.

Best Regards,

#11

It might take me a while. I’m really busy. :frowning:

#12

(post deleted by author)

#13

@gosteamlib NVM, I added it. Please allow 2 – 3 weeks for the extension review process. I hope it will work for you!

#14

Ok I’ll wait :slightly_smiling_face: .

Best Regards,

#15

No problem! I hope it will be updated soon. I’ll let you know when it is.

image
image.png1595x409 52.1 KB

#16

Oh, by the way, I uploaded the version to ‘1.0.1’ with some fixes in ‘Servo Motor’ block
and the status is ‘In review’.

Could you included those fixes as well?
Thanks.

Best Regards,

#17

Yes, when I have time.

#18

Hello~ Still on review?

Thanks.

Best Regards,

#19

I’ve tested with the broadcast ext which you provided and changed ID and version.
image

And erased some of supported devices.

image
image.png699x287 6.1 KB

But broadcast was not working.
This is the extension which I’ve tested.
arduino_broadcast_steam.zip (75.8 KB)

Would it be better to wait for the official Upload mode ?

Thanks.

Best Regards,

#20

Yes, probably. You can contact mBlock

support@makeblock.com