I purchased the laser engraver upgrade recently and the laser barely engraves into the wood.In the beginning it was working right but now even on slowest settings the engraved line can’t be seen.I am even not using a hard wood (paulownia)
Any solution for this?The laser does burn when it is on place and when the arm is moved by hand but when I start the engraving it barely engraves into wood.
Problems with the laser
Blecky
#1
tech_support
#2
Hi Blecky,
Please increase the value to Power and Delay in the settings have a try.
For further feedback, please send email to tec-support@makeblock.com
Best Regards!