I’m having a problem connecting to the device, I’ve installed the drivers and then ran mdraw. When I try to connect to the port it’s on I get a connected status and and idle but as soon as I try to move the pen up or down its just says busy. Can I get detailed instructions on the wiring? It’s on the windows platform.
Problems with mdrawbot kit in ms Cara mode
Kastley
#2
Checked the wiring again and everything is hooked up right but still no response from the drawbot
tech_support
#3
Hi Kastley,
Which robot form you have assembled for mdrawbot? mSpider, mScara, mEggBot, mCar?
Have you chosen the correct robot form on mDraw, besides, have you upgrade the firmware?
Here is a link to download all the instructions for mDrawbot: http://learn.makeblock.com/en/mdrawbot-kit/
