mElephant 3D printer autoleveling bed problem

#1

Hello!

I just tried to use my mElephant printer after 1 year.
I remember before, the autolevelling worked fine, now not.
I will try to explain :
The Z axis went down till the detection of Z min, then it went up and down slowly to detection and then go to next point.
Now the Z axis go down to detection (and make the detection) and don’t go up, it goes directly to the next point.

I don’t know if there is a new firmware or maybe a problem to the gcode G29. Maybe there is a method to get the to factory settings.

Thank you for the help :slight_smile:

#2

Hi redman6150,
http://learn.makeblock.com/en/melephant-3d-printer/
You can get the resources about mElephant from here.
Thanks.

#3

Thank you for your answer :slight_smile:
I will take a look and give more feedback :wink:

Thanks :slight_smile:

#4

Hi redman6150,
Hope you will enjoy playing with our Makeblock products.
Thanks.

#5

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.