MeCompass calibration problem

#1

I have a little problem with my MeCompass sensor that I connected to the MeAuriga baseboard. Even though I press the button, the blue LED only flashes 2-3, but it does not switch to continuous flashing, so I cannot calibrate the device. I uploaded the test program from the MakeBlockDrive directory of the Arduino IDE and I do everything as described, but the module does not switch to calibration mode. I’m waiting for help and advice. Thanks!

#2

Hi:

Did your sensor exceed the warranty? if not,you can contact with local distributor to replace or fix this module.

#3

Hi:
Thanks for the advice, I will try to contact the seller.

#4

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.