So the specification sheet for the Me High-Power Encoder Motor Driver says 6V-12V. However when I looked at the electronics diagram shown here https://www.hackteria.org/wiki/images/5/5b/MakeBlock_Me_High-Power_Ecoder_motor_driver.png next to VBatt it actually lists 24V as an option as well. Could you confirm whether I can run a 24V motor using this module? Looking at the electronic components I believe they are rated for this voltage (but I have only a very basic electrical understanding)
Me High-Power Encoder Motor Driver able to drive 24V?
tech_support
#2
Power input voltage is 12~24V;
As motor output voltage is 6~12V, it cannot drive a 24V motor.
system
#3
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.