Had the old mbot w Orion, then for an upgrade, purchased the Auriga board. Didnt realize the Auriga used encoder motors and did not buy the ME dual motor driver.
I’m looking for a hack (that wont kill any parts) to run the motors as-is. I tried just hooking up the M1/M2 +/- with various motor commands in mblock, but no go. (you can tell I’m not an expert)
Anyone have any ideas? I have a few but Ill keep them to myself.
Hi Roninisc,
Old mBot w Orion, so, is your kit “Starter”? And below is your motor? 25 DC motor？
If yes, to get it connected with Auriga, you can buy the DC motor driver:
Yes, and yes. I stated that in my post.
Was wondering if there was a trick or hack to do it without the board.
One main reason I ask is that the DC motor driver is out of stock everywhere. Do you know how I can get one?
What else will work?
That board did not come up w search on amazon first time, thanks.
Still curious about self connect. I have the dupont cable and available board pinout pdf, if that is what you mean. The question, yet again, is how to actually do it.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.