mCore GPIO map?


#1

Hello there. I program my mBot on a Linux system, which means that I have to use arduino-cli. I was able to use the port number found in the example sketches for the ultrasonic sensor and the light sensor, but it doesn’t seem to work for the RGB LEDs and the GPIO map in MeMCore.h does not help at all. In MeConfig.h I found this link:
http://learn.makeblock.cc/Makeblock-library-for-Arduino/index.html, but it’s dead. Is there any proper documentation for the mCore somewhere on the Internet? Thanks a lot for help.


#2

Hi checkout this link