Laserbox vs lightburn


I’m using both laserbox and Lightburn software and getting different results. I try to setup the Lightburn with similar setting to that in laserbox when engraving stainless steel, but the result is a poorly engraved (marked) tag. I’m using Lightburn to setup a jig to engrave tags and would like to use this software to engrave as well with the jig developed in it. On the other hand, is there a way to use the Lightburn jig file in laser box with the much better resulting engraving? I hope this makes sense.
Suggestions would be much appreciated!


Have you tried the xTool support page?


This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.