How to Use Encoder Motor in New Products Test Project

[Johnny]

Continuing the discussion from 【Test Projest】For the New Products Test Project:

【Test Projest】For the New Products Test Project

1, download the file EncoderDriver.zip and unzip it. Then you should use USB-TTL Cable burn the driver code to the encoder driver module. There is a MCU on the module.

Just like the pictures below,

;

;

;

Driver Vcc -> 5V USB TTL
GND -> GND
TX -> TXD
RX -> RXD

And, make sure you choose Arduino UNO in arduino IDE.

;

Push the reset button on the encoder module when the code just finish compiled and start uploading.

2, update the library (v2.1.0318 at least). We have add an example code of encoder motor.

That’s all. Please post everything you got when you use that. Thanks!

[Evgen89]

Driver USB UART
GND >>> GND
5V >>> VCC
RDX >>> RX
TDX >>> TX
For USB UART driver downloaded CDM v2.12, before programming the driver writes the firmware EncoderDriver.ino (http://forum.makeblock.cc/t/test-projest-for-the-new-products-test-project / 435/11 ) for coding the driver when you use the Encoder Motor Tool can not connect and read settings (key get), although the display connection is present .

[system]