Hello people,
I made a program with the kids at my work, following a example online.
its a linefollow program which had to be uploaded to the mbot with the arduino mode.
(1st is a mbot block)
We uploaded the code to the Mbot and the program worked, but now we have a problem.
The Mbot keeps on going on with this program even when we reset the Mbot or we put it on or off.
How can we get the Mbot out of this modus again ?
Need help despertly cause of a demo with the Mbot this thursday…
thanks
You need to upgrade the firmware and restore the default program. Read this page, especially the guide pdf page 10: http://learn.makeblock.com/getting-started-programming-with-mblock/
@tec_support … can we please make a link to this page and guide as a sticky in the forum?
It’s not a matter of getting a program out of the mBot, as it is over writing the program that is in it. All of the Arduino based boards can only have one program in it. The power and reset will only reboot the program that is currently in the mBot. By restoring the default program, you will over write the program that you last uploaded to it.
Mike
Hi Andreas,
Thanks for your suggestion.
It is a whole PDF which uploaded on the learn website. I may able to make a link to this page individually. Here we can paste the screenshot for this page.
