How to connect 10 servo-motor

#1

Hello guys!
For my project i need to connect the maximum number of actuator (ACTUONIX PQ12-100-6-R) to a single board, and it says that the MegaPi can handle up to 10 servo motor at the same time, but it only works from pin A6 to A9. Is it possible to connect actuator to pins from A10 to A15 ? It would help so much if it is.

#2

Hi Rayane:

This is the parameter of Mega Pi,it has 6A current protection so you need to calculate the current of all the servo-motor,make sure it will not damage the mainboard.

ØMain control panel:Mega Pi(Mega 328P)
ØMotherboard power:24W
ØOperating voltage:6v ~ 12v

#3

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.