Getting Started -- first steps and some questions

#1

I just set up the robot and played around with the remote. There seems to be a mode that follows movement that we could activate by holding down one of the buttons. After reading the documentation we have, we still have the following questions:

(1) How do we find the default software/modes on the Orion board?
(2) How could we restore this software? Is it possible to get the code into scratch which would enable us to edit and expand the code?
(3) Is there an online repository of code that we could download with cool ideas?
(4) We wanted to make a buzzer cycle or to cycle the led’s, but we couldn’t find any documentation on this. From our guesses, we weren’t sure which ports these connected to. Where should we go to find documentation?

Thanks for any help,

Tim

#2

Hi Bonhoeffer,

Which robot kit do you have? The I can send you the correct instruction to reset default program. Or you may find the robot you have in this link which provide more info to you for reference: http://learn.makeblock.com/en/
About mBlock program, here is a link to you for reference:http://learn.makeblock.com/en/getting-started-programming-with-mblock-2/
As for the explanation for the ports on Orion board, please refer to this link: http://learn.makeblock.com/en/makeblock-orion/

#3