Firmware update on orion

#1

Hi,
my Orion board stop responding therefore I followed the instructions suggested by evan_xy in the pinned topics with an Arduino Uno board to burn bootloader.
After that I uploaded the latest firmware to the Orion but this is the message I get:

This report would have more information with
"Show verbose output during compilation"
enabled in File > Preferences.
Arduino: 1.0.6 (Windows XP), Board: "Arduino Uno"
In file included from mblock_firmware.ino:12:
C:\Program Files\Arduino\libraries\Servo\src/Servo.h:67:2: error: #error “This library only supports boards with an AVR or SAM processor.”

Any suggestion for correcting the event?
Thank you,
E

#2

Hello

You can use mBlock software to upgrade firmware of Orion board, Please download it on http://learn.makeblock.cc/learning-scratch/

#3

Hi Peter,

I used Scratch and at the end of updating the firmware I get the message “Upload finish …100%”

Using the Arduino software while loading the BaseBoardBuzzerTest the message I received is the following:

Binary sketch size: 3,780 bytes (of a 32,256 byte maximum)
avrdude: stk500_getsync(): not in sync: resp=0x00

The serial port and board are correctly selected.

Looking at the led on the Orion during the transmission, i notice very fast blinks on the RX led and no blinks on the Tx led.

Any other suggestions?

Thanks,
E

#4