Encoder motor does not work with my Me Auriga (mBlock)

[wim_den]

I am using mBlock to program the Me Auriga. I want to use the encoder motor and the led if I receive a signal.
The led light up but the motor does nothing. Any ideas?

!
wimden

[tech_support]

You are suggested to use a simple program to test the motors, including check the wiring.

Make sure battery can provide with enough power.

[wim_den]

It works. There was a problem with downloading the program to the Me Auriga.

Wimden

[tech_support]

Nice

[system]

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.