Benbox - Changed XY parameters and messed everything up

#1

I’m using the XY Plotter with Benbox software and the laser engraver module.

In the parameter menu I opened the arrow on the right and changed the values for the Step, Direction, etc. and did not write down the original numbers. Now it won’t draw an image properly. Does anyone have these values so I can enter them back in? Also, nowhere is there a page that explains this menu.

#2

Here’s what I copied down. However, Benbox is not working with my XY plotter.

   x        y

step 10 9
dir 11 3
min 17 13
max 16 12
ppm 174.9 174.9

laser 5 6
servo 15 20
Feed rate 3000

#3