Add Esp32 based board

MeKAnick 2021-12-11 05:00:36 UTC #1

Hi.
I am trying to win an Esp32 Wrower -E based card to the mBlock 5 device library. I have shared my Connection settings in the images below. The device I added is connected and the firmware can be updated. However, when I want to load the code blocks, the loading window does not start at all and does not give an error.

Which settings should I pay attention to?

Connection Setting:

makeblock.lindingxin 2021-12-13 01:15:51 UTC #2

Hi:

ok,we’ll check the codes for you later once we figure out the problem we’ll reply to you ASAP.

makeblock.lindingxin 2021-12-13 05:59:10 UTC #3

Can you send your codes to my Email? thankyou. lindingxin@makeblock.com

makeblock.lindingxin 2021-12-13 10:00:20 UTC #4

and your ext file by the way,thanks.

MeKAnick 2021-12-14 05:16:59 UTC #5

Thanks for your feedback. I sent the email.

makeblock.lindingxin 2021-12-14 06:14:13 UTC #6

Hi:

There is a problem with the upload script, the uploader variable is not defined, and it is used directly

Just add these three lines in the public code

Add a new device based on ESP8266