Xtool D1 Pro only cutting vertically


Hello all,

I finally got to use my Xtool D1 Pro 10 watt laser and ironed out the kinks and when I went to cut the Maple leaf design that is standard in the Xtool Creation Space application, the wood I was cutting was only cutting it Vertically.

I inserted the image, ran the framing setup and processed it. btw, I have Air Assist on and please see the attached photo.

Prior to processing the image, I loosened up the one belt that was a little tight.

Any help would be great and I appreciate your time and advice.



Perhaps re-tighten the belt?
Try the xTool support page: