Hello
We are making the mgiraffe 3D printer.
And we have the MINTEMP ERROR but we have dubbel checked everything already.
We have measure the wires and that’s okeay.
We have seen already the other topic from an other guy on the forum. http://forum.makeblock.com/t/giraffe-3d-printer-err-mintemp/5163
But we have always the same fault.
Can you help us please?
Thank you.
Greets Emile and Matthias
Hi Emile,
Is this the first time you use the mGiraffe 3D printer? Or was it working before?
For this issue, have you tried swap the order of the two wires coming from the thermistor?
Hi
It’s or first time we use the mGiraffe 3D printer.
We have found the issue it was the 2 fans that we have swap.
Now we do the debugging part but we don’t find the COM3 in the program.
We have found it on an other pc but now we don’t find it.
We gonna take tomorrow the other pc.
Hi Emile,
As suggested in the email, please install the Arduino driver on the computer have a try.
