Want to get back to factory settings on everything

[alxengel]

Have managed to mess something up so that Serial port is now on COM4 instead of COM3 (as it was from the start) and now nothing works. I am not 100% sure that this is the root cause. Robot was a paperweight. After “Resetting Default Program” under connections, the robot now runs forward non stop and cannot be controlled. How do I get back to factory settings?

[rojoamigo]

FAQs for mBlock--20170608

If you have any problems with mBlock software, welcome to visit our [mBlock main page] (http://www.mblock.cc/docs/). Or visit the FAQs below: 1. What boards does mBlock support? mBlock supports all controller boards produce from makeblock, such as Orion, mCore, Auriga, MegaPi; And all makeblock boards are developed based on Arduino, so mBlock also supported original boards from Arduino, such as Uno, Leonardo, Nano, Mega 1280, Mega 2560. 2. How many ways about connecting makeblock robot/boar…

[tech_support]

Hi alxengel

First, let’s confirm you have the robot showing on picture below:

Please refer to this post to reset default program for Starter robot have a try.

Once it still functions the same way, please upload the following example program for Starter and see how it functions:

Besides, there is a FAQ list for Starter robot to you for reference.

[system]