Nervous bird part of the Ranger

#6

The online firmware is the latest firmware for mBot Ranger. There is no default code that mBot Ranger comes with, if that is what you mean. If you want a code for the nervous bird, you will have to make one.

#7

Sorry that was a bit late.

#8

Have you tried say unplugging the motors and such? I don’t quite understand your problem.

#9

I unplugged everything, no good

#10

Strange. Maybe it is a hardware issue.

#11

You can contact mBlock
support@makeblock.com

#12

I’m going to set up the ranger again and try that, maybe it’s a gyro problem

#13

Maybe. Do you have a specific nervous bird code, or is this the app?

#14

It’s the app. I just notified support, so we’ll see.

#15

Yes, the app has trouble.

I use the PC version.

#16

I’m new to all this, but I’m very careful about how I put this together, and the ranger worked fine.

#17

Yes. It is trouble with the app. Not your fault. :slight_smile: I hope you get them to fix it. I’ll contact them, too.

#18

Glad to here I’m not the only one having a problem.

#19 

*hear
#20

But yes. You can try to make a code on PC for it.

#21

Like I said, I’m new at this,I have no idea how to write code for it

#22

Oh, sorry. You can try a code like this:

image

I haven’t tested it yet, though, so it might need a lot of tweaking.

#23

Thanks, I’ll give it a try, but I’ve uploaded some simple code and it runs the code, then the motors keep running until I turn it off

#24

Maybe you didn’t put stop moving

e.g.,
image

Mblock wait() function is not accurate
#25

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.