MElephant Marlin uploading failure

#1

Hi team,

I Try to change a few settings in the Marlin Firmware to disable Z=0 height sensor etc.
uploading net Marlin from Arduino IDE does not work.
Ik read some posts on the forum that I ned to download the U8glib and place this in my Arduino libraries folder (did that)
I tried several versions of Marlin, I saw you provided for another Forum-user but they all keep giving me compile eroors.

Questions:
Do I need to do anything other that just place the U8glib in library folder of my Arduino IDE (no install?)
What extra info would you need to see where this goed wrong?

best regards
Floris

#2

Hi FLLoris,

There is compiling error with the original marlin firmware (without modified)?
Please take a clear picture for your mElephant printer, thanks!

#3

Yes, I have tried the original MARLIN without any adaptations to check if uploading would work anyway (before I started making changes). I saw in earlier post on this forum there seem to be 3 versions of the Marlin firmware out there. I tried all.
I have the version of the printer with the Z-axis couplers (see photo)

IMG_9734.JPG1224x1632 697 KB

I must say I wonder whicj Arduino board I should choose in Arduino IDE to upload to. Mega? Uno?

#4

Hi FLLoris,

Please try this marilin.SH1106 Opanel-coupling.zip (1.4 MB)

The Board is Arduino/Genuino Mega or Mega 2560. Here is a instruction to guide upgrade firmware for the printer.How to Upgrade Firmware to mElephant printer.zip (531.3 KB)

#5