Hello,
We have a problem with the motion software.
We use this stepper:
Typ 23LQ-2202-01H, bipolar, 5°, 72 steps,
and the me stepper dip switch: 1/8,
and the Aurigia board
The Problem:
The motor runs 1 step forward and then 1step backware,etc.
we use the code:
Hi Sanoj,
Please send me a photo of your motor and also share me the code in English.
Also it will be better if you can take a short video to show me the behavior of your robot when running this code.
Please send the information to support@makeblock.com
Thanks.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.
