Hi everyone, I recently purchased a feetech servo ( FR5113M) for my mbot but I can’t make it work properly.
Equipment : mCore board; 2 standard dc motors, 8 AA nimh 1.2V battery (2400 mAh & 2000 mAh); wifi module; Me RJ25 Adapter and Feetech FR5113M servo.
I plugged everything as ou can see in the picture but it only worked for a day and the battery were not fully charged so I don’t think it’s a battery issue. The 2 dc motors works fine but the servo don’t, even if I hear clicks inside and I see it move a tiny bit. Sorry for my bad English I’m French
.
I have just tested it again with the same battery and the same code but with a multiplex servo tiger digi 4 instead and it works. But the torque and the holding power of this servo are too low for my project. So I need to make the feetech work.