Been using the starter kit with a BME280 and a couple of LEDs ,that are not off makeblock, had no problem till for a week as the kit was a part of a work experience challenge but now my orion board won’t sync with my iphone and I can’t upload the blink program to test it.
whilst i used it in the space of 5 mins the chip closest to port 5 got hot enough to burn ,which subsequently occurred.
If anyone knows what to do I would appreciate the input
Hi Undeadsniper118,
You may keep the RJ25 Port on the Orion board empty while uploading a program to it.
If it still upload failed, you can try remove all the electronic modules from the Orion board and test again.
Once still the error, you can take a picture for the details of the error.
there were no modules or motors attached to the board I tried using blink but could only program it by going through the ICSP but it would not sync to my phone via the bluetooth module once download had finished and everything refitted. Gone and bought the Aurgia board to see if that will have a better effect
Hi Undeadsniper118,
Thanks for the info, hopefully you can receive the Auriga board soon and everything goes well.