LaserBot Motors don't move

#1

Launch mLaser. Input Password. OK.
Click Update FW. Lights Flash with success.
Reboot OK. Click Next Step. Click Connect. Dialog box says connected.
Press the X and Y limit switches and the corresponding letters change color in the SW.
Click Start Machine Self-Test. NOTHING Happens.
Click Next Step. Adjust Laser Focusing. OK.
Click Next Step. Click Start to Test Engraving. The laser turns ON and blinks like it’s engraving, but the motors are NOT MOVING, so it’s just burning a single spot.

I had assembled the LaserBot a few months ago. Printed a couple of test images. All looked OK.
Left it alone for some time.
Have been trying for the last day.
Any Help is appreciated. Thanks.

#2

Hi Omair,

Have you turn the power switch on the Orion board to ON side?
If yes but still the issue, here is an instruction with the troubleshooting for this issue4. LaserBot_How to fix if the X-axis or Y-axis cannot move when test home.docx.zip (3.2 MB)
, please refer to it step by step have a check.

Besides,here is a post with FAQs for Laserbot to you for reference.

#3