Code does not upload to mCore

#1

Hi,

I downloaded the mBlock new version(V4.0.4). I wrote the following code block and tried to upload to mCore. I waited it to load but it did not upload to mCore.

mblock
mblock.png1348x704 88.4 KB

It worked before when using in previous versions of mBlock.

Do you have any idea?

#2

Hi gungorhilal,

What is the operating system of your computer?

#3

I am using the windows operating system. (windows 10, 64-bit processor)

#4

Hi gungorhilal,

Here we tested it on Windows 10 computer and there is no problem uploading program to mBot.
How about totally uninstall the mBlock software and re install have a try.

#5

Hi tec_support,

Thanks for reply.

I re-installed the mBlock program. I think there are some problems in this version.

I uploaded the first code, and it works. When I want to load a different code, it gives you a warning as you see in the picture. I waited 5-10 mins and tried to upload again and it works. Sometimes the program gives that warning, but sometimes it works.

mblock
mblock.png1288x738 85.1 KB

Thanks again:slight_smile:

#6

Do you have a block somewhere (maybe in another sprite) which is not possible in Arduino mode? Try again to start from a blank program.

#7

Hi Andreas,

I tried it many times and don’t have another sprite/block.

Thank you for your suggestions.

#8