Auriga Auto On When Power Connected


#1

I have a project whereby the Auriga board becomes a little difficult to get to. Is is possible to have the board switch on automatically when 12v power is connected? I had the idea of soldering the on/off connector closed, but it looks like the board powers down again after a few seconds…


#2

I am afraid there is no project to auto switch on the power. I also have the same thought that do some change on the pins of the switch to make it always on, so that it will be on once connected to power adapter. But it is not suggested to do so.


#3

I also have a similar project. The program has to start with a remote. The solution might just be that. Have the auriga on and start/stop the program via remote control. I have not implemented the remote control part yet. Can anyone share their remote control solution?


#4

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.