Need help for :StarterKit + me-shield + raspberry + megapi


#1

Is there anybody who can help me to correctly understand and configure me-shield RPI whith an raspberry PI 3

i have many bug and i don’t know if it’s a hardware error or an software config error

Please help me !
is there any procedure to success…

i am french young boy and excuse my poor english talking

Makeblock Starter Kit IR / Me-Orion
Me-Shield RPI (http://www.makeblock.com/me-shield-for-raspberry-pi/)
Raspberry PI 3


#2

Hi,

You may refer to this link for more info of me shield for raspberry.


#3

hi again,

can you check my screenshot and explain me what’s wrong ?

https://1drv.ms/i/s!Al3MJbN40ZenkuFhBGUfSuswwybLRw


#4

More files… and tests…
i have add into /boot/config.txt
enable_uart=1

i always have same result : [Errno 25] Inappropiate ioctl for device

screenshots :
https://1drv.ms/f/s!Al3MJbN40ZenkuFgVflQKesCXsJ3XA

Regards


#5

Hi Quidam,

For this kind advanced usage, I am afraid that we don’t have enough ability to support, maybe experienced raspberry users can help.
To check if the Makeblock boards are working or not, you may just upload some example programs from Makeblock library to it have a check.


#6

i am appalled by your response


#7

it seems that YOU are the right entity to solve this bug !
it’s you technologie, your tools…

It’s easy for you to boot into touch


#8

Hi Quidam,

The me shield for raspberry pi is just a transfer board providing the serial communication between the Arduino board and Raspberry Pi (it is just equal to connect TX->RX, RX->TX, GND->GND, VCC->VCC). If you use this module, you need be very proficient in using the serial communication on Arduino and raspberry Pi.
So if you ask how to program this module, we don’t have more supported instructions except the info on the learn website. It is recommended that you learn more related content about arduino and raspberry serial communication. Hope you can figure it out by yourself.


#9

i’m sorry but you are not serious, your answer is a nice joke,
Many people post everywhere messages of difficulties to set Rpi 3 with me shield !
And no universal answer can be found for a config from scratch (noobs for example)

It was very simple for you (for example) to set an Raspberry iso from scratch with the right configuration and put it on th git hub and you never see more about difficulties !

It’s not Professional and out of fairplay for young people… Etc…

Br


#10

I think that make a real sample config for raspberry pi 3 take less time for you opposite time to response many questions on blog, forum and else

It was also greater for your reputation…


#11

For example my config is basic
Raspbian pixel from Noobs

No more simple…


#12