I used my laserbot before but now I can not connect to the port. Does somebody have a solution?
A screenshot:
Mlaser does not connect to port (Laserbot)
AEON5
#1
General things to look at:
- Is there anything else trying to use COM4?
- Is the port speed correctly set?
@tec_support, that’s all I can think of because I don’t own the laserbot.
tech_support
#3
Hi AEON5
From the picture, I see the COM4 is not the correct serial port for the Laserbot.
Please download from this link , pull down the page and you can see the FAQ part:
Please install the driver and check if there is a COM port corresponding to CH340 under device manager while the Laserbot connected to PC with USB cable.