Me Auriga + Me stepper Driver + Stepper motor

#1

Hi,

I was running a stepper motor today its connected via Me Stepper driver through RJ25 to Me Auriga Board. It was running fine this morning however its not working anymore using the same code.

what could be the possible causes that all the sudden it stopped working?

I think my stepper motor driver may be faulty…

Thanks for your help in advance.

#2

Try running through the following sequence:

  1. Upgrade Firmware
  2. Reload your program

If that doesn’t correct it, try:

  1. Upgrade Firmware
  2. Reset default program
  3. Reload your program

If that doesn’t work, contact @tec_support. :slight_smile:

#3

Hi
I am experiencing the same issues that Alan is experiencing,
did you manage to come to a working solution or was a new part ordered?
Thanks
Brad

#4