How to synchronize motors in create mode


#1

Is there a way to start up or adjust multiple motors in a single command?
It seems that “Set throttle” takes quite a lot of time, so one motor starts some time after the other.
(On an old 7" Asus Zenpad)
Thanks!


#2

To control the motor alone, there is only command “Set throttle” to control each motor single. It is normal that one starts some time after the other due to the slightly delay of executing the graphical program block.

Only the program blocks like “drone [rising] for 1 s” in air mode, they can control several motors synchronize.


#3