3D printing problem: waved walls


#1

The problem

When I print with mElephant, the prints come out with waved walls like in the picture below. I am using PLA filament from https://makeblock.lt/steam-platformos-3d-plastikas-pla-plastikas/

What I tried

I tried changing temperatures 190-220, tried to change the flow rate. Also checked if the bolts are not lose. Everything seems good.


#2

Hi gpson,

When you gnerate the gcode file and install the Arduino cura, please make sure all the settings are match the ones in our video tutorials. Please keep all the other settings as default if they doesn’t need to change according to the videos.

Please kindly refer to the two videos in this link to gnerate your gcode and set the cura settings again have a check.

Once still the same issue, please send us your original 3D model.


#3